Consider changing your processor from Intel's 14700k to AMD options like 7800X3D or 9800X3D.
Consider changing your processor from Intel's 14700k to AMD options like 7800X3D or 9800X3D.
I’m just exploring new options, everything looks fine with my setup. I’ve been excited about the upcoming chip releases and have been eyeing the latest motherboards from both AMD and Intel. At the same time, I’m trying to balance GPU performance for 4K playback on an LG C4 while keeping my frame rate steady at around 144fps without sacrificing graphics quality. Honestly, I don’t think a major overhaul is necessary—my current 14700k setup with an Aorus Z690 Ultra and DDR5 6200 should give me about 20 extra frames.
I’m more comfortable with Intel right now, so I’m seeking insights on AMD’s approach. I’m leaning toward a new x870/e board, mainly considering the Asrock Nova or Taichi Lite because their PCI lane configuration works well for those chips. I know the 7800X3D and X670 models struggle with stability at memory speeds above 6000-6400MHz, so adding a 7800X3D to an x870 board could be risky. What temperature expectations should I have from an AMD processor paired with a 360mm AIO during gaming or benchmarking?
I recently upgraded to a 600 case, which is a bit warmer than a typical setup, so I’m looking for a cooler-running chip. In benchmarks using a 360mm Phantom X with D30s, my 14700k reaches around 80°C. I’m gradually lowering those temps by tweaking fan curves and placement—I’ve managed to bring it down to 72°C, whereas my previous case was at 64°C.
Any advice would be really helpful.
Feedback would be very welcome. If you have to spend, it should come after the RTX5090 is revealed.
Price around 14700k with an Aorus Z690 Ultra and DDr5 6200.
You might get a bit more FPS if you used a low-latency setup at DDR5-6600Mhz with two cards.
Right now, you only mentioned the RAM speed, not the full specs.
Perhaps opt for a standard layout when buying now, like a case with a connected front panel.
Intel processors can be temperamental, but I wouldn’t splurge on a platform change so near CES 2025.
You're likely correct, I should switch to a reverse order and upgrade after the 5090. I like to match my GPU and motherboard manufacturers together, just like I did with Gigabyte.
I think I could increase the memory speed; I'm using a 48gb Corsair Titanium kit with an xmp2 profile, and I haven't made too many changes because I had trouble getting stable performance at 6400 with a G.skill 32gb kit.
I considered replacing the radiator and fitting a 420mm one into my case, which could save about 2-3C if it works. Spending $114 on an Artic Liquid freezer 2 and installing my D30s would be worth it unless Artic fixes the freezer 3 plate design for Intel.
In any case, I value the feedback. I enjoy tinkering and usually buy and resell my used gear to coworkers, so out of pocket I might spend $300-500 on new tech about half the time.
If the funds are draining your wallet and no one will stop you, try it out. Even though running the same applications on both devices might not make sense, it’s still worth a shot. When I set up a 7950X in December 2022, I bought a 2x32GB DDR5-4800 module without any XMP overrides. Anything cheaper locally was too costly. Sure, I sacrifice some performance, but I prioritize reliability during extended rendering tasks longer than 24 hours.
For high XMP configurations on X670 or X870, look at user reviews that compare specific RAM modules with mid to high-end systems and compatible CPUs. Keep in mind the variability of the silicon market—same part numbers don’t always mean identical results. It’s a useful reference before making a purchase.
Money keeps running out of my pocket all the time lol. I wish I could earn more to contribute something worthwhile at work lol. Over the past four years in my department, I've developed five machines (intel rigs) for myself and whenever new hardware comes out, I upgrade and sell the old ones at fair prices. Now I have a group of friends who enjoy playing World of Warships and other games, of course.
Regarding XMP settings, I've been closely following overclocked communities on memory timings and speeds for the new X870 boards. So far, I haven't gathered much real-world data on actual gains from moving from 6000 to 8000+ as the new standard. It seems like a possible improvement of around 1% in FPS, especially with the new chips when playing in 4K.