Configuring a 10GbE SFP+ home network. Recommended gear and cables for optimal performance.
Configuring a 10GbE SFP+ home network. Recommended gear and cables for optimal performance.
The router doesn't require the RJ45 Transceiver. The fifth port serves as a standard (+management) 1gbit RJ45 port, which I personally use for the upstream connection.
Sure thing! The switch does provide Layer 3 capabilities via routerOS, which means it can handle routing tasks. You could definitely use it as your main router while placing your 2 gigabit devices underneath in AP mode. The switch would act as the DHCP server and manage port forwarding. Management access is typically limited to the RJ45 port, not the other connections.
I've only used it as a basic switch and haven't explored its advanced settings. It seems to offer standard management tools such as VLAN, though I'm not sure if that's complete.
Typically you require a 10gb connection to just one server or PC (though two devices aren't necessary, you can set up a mesh network with varied subnets). For home setups, connect directly between the device you wish to reach and a 10gb link. With two 60€ MicroMax cards and a direct cable, you can overcome the challenges. I've done this... it cost a 10gb switch and about 180 watts for one minute in a 23:59 day... getting the NAS near the PC makes sense.