Configure your home network for seamless connectivityHome Network Configuration
Configure your home network for seamless connectivityHome Network Configuration
I'm arranging a mesh network in a 2600 sq ft residence with AT&T Fiber internet. I've purchased a TP-Link TL-SG1005P POE+ switch and two TP-Link Deco AX3000 units. The plan is to connect the AT&T router via the switch, using both Decos as access points linked to the switch. Since this setup is wired, I anticipate full utilization of available bandwidth—500 Mbps in 2.4 GHz and 2400 Mbps in 5 GHz. I have no prior networking experience, so any advice or observations would be greatly appreciated. Note: The home uses Cat 6 cabling to mounting points; Decos will be mounted on ceilings. I intend to switch to a higher plan later if needed. TV and PlayStation connections will be wired, while the surround system will be wireless. Smart switches, lighting, and appliances will also be integrated. Thanks for your guidance.
Remember to use the AT&T gateway in IP pass through mode. AT&T mandates customers utilize this device, which also serves as your ONT. IP pass through bypasses router operations on the device. Then connect the ER605 and it should deliver your internet IP. Don't do that. WiFi often falls short of its advertised performance. Frequently, speeds are constrained by connected devices because of antenna configurations or antenna count. Various factors can also disrupt WiFi signals. Still, mounting it on the ceiling helps extend the range and you should expect reliable speeds.
I prefer consumer-oriented options, while the ER605 seems better suited for business and premium users. Focus on the speed of NAT processing—it determines how quickly your internet performs. TP Link might not have released those figures, but you should check the WAN to LAN and LAN to WAN rates.