Configure the correct voltage settings for the B450M mortar and 3600 system.

F5F Stay Refreshed Hardware Desktop Configure the correct voltage settings for the B450M mortar and 3600 system.

WaterLily2003
Senior Member

648

12-10-2019, 09:09 PM

What voltage should be used for your B450M mortar? It's currently around 1.35V with stock cooling, and you're running a 650W PSU. I'm not sure what the correct values are, so checking DRAM calculator might help. Your RAM modules are F4-3200C14-8GTZRX.

WaterLily2003

12-10-2019, 09:09 PM #1

DrXOff
Junior Member

12-30-2019, 08:40 AM

Great selection for memory storage. Works well at 1.350v. Additional units may be required if exceeding XMP capabilities.

DrXOff

12-30-2019, 08:40 AM #2

Great selection for memory storage. Works well at 1.350v. Additional units may be required if exceeding XMP capabilities.

Lord_Sanguine
Member

100

01-11-2020, 08:28 AM

What do you think about soc?

Lord_Sanguine

01-11-2020, 08:28 AM #3

What do you think about soc?

_MissBlue_
Junior Member

01-25-2020, 11:10 AM

Typically, SOC operates automatically with over-volt protection. You can also set a manual input of up to 1.1v safely.

_MissBlue_

01-25-2020, 11:10 AM #4

Typically, SOC operates automatically with over-volt protection. You can also set a manual input of up to 1.1v safely.

barkris123
Member

02-01-2020, 06:39 PM

These readings reflect my setup without PBO. The RAM module is configured at 1.41V.

barkris123

02-01-2020, 06:39 PM #5

These readings reflect my setup without PBO. The RAM module is configured at 1.41V.