Completing my first build
Completing my first build
Hello everyone,
I just got my 8700k and am planning to assemble my system. This is my first build, so I’m looking for some guidance on a few questions. Your support means a lot. I checked the forum for advice and wanted your opinions.
I’m considering splitting the 8700k – I bought Kryonaut and was thinking about applying it before installation. I don’t want to have to reapply it twice (I already have 11g).
I also want to know if I should remove the stock thermal paste on the 360 AIO and use Kryonaut for improved conductivity.
Additionally, should I do the same for the 1080ti to achieve better boost and lower temperatures? Would Kryonaut or Conductonaut be more suitable?
My setup allows side mounting the radiator. I plan to install three 140mm fans at the top, three 120mm fans in front, and one 140mm fan behind the case. Is this the best configuration for optimal airflow, or should I position the 360 rad somewhere specific (I’ll be doing a vertical GPU mount)?
Here’s my current setup:
Intel 8700k
AsRock Taichi z370
Corsair Dominator Plat 3333hz 16gb
Thermaltake View 71 RGB
Thermaltake 360 AIO RGB
Thermaltake 850w Tough Power RGB
ZOTAC 1080ti Amp
Samsung 950 pro 512gb SSD
Seagate 3TB HDD
4x140mm, 6x120mm RGB fans
Any suggestions would be greatly appreciated!
I would start by getting everything operational first. Then proceed with extended overnight torture tests on the CPU and GPU. This ensures both components function flawlessly before disassembling them and voiding your warranties. Maybe just monitor their temperatures during testing to avoid wasting time and damaging parts. By removing the CPU and GPU heatsink, you can achieve superior thermal performance. Conductonaut is the superior choice here, despite being riskier because of its better conductivity.
I wouldn't suggest removing the new processor. Doing so would likely cancel the warranty. The advantages of doing so are minimal, and you won't be able to see any changes afterward (the MHz might increase slightly during an overclock).
I would start by getting everything operational first. Next, perform extended overnight tests on the CPU and GPU. This ensures both components are fully functioning at 100% before disassembling them. You might want to monitor their temperatures during testing to avoid wasting time and damaging parts. Consider removing the CPU and GPU heatsink for optimal thermal performance. Conductonaut is the superior choice, though it carries higher risk due to its conductivity.