F5F Stay Refreshed Hardware Desktop Can I revive my PSU?

Can I revive my PSU?

Can I revive my PSU?

W
wintery_kid13
Member
158
09-29-2016, 08:45 AM
#1
Your gaming PC stopped working suddenly with a crackling sound and no power detected from the PSU. It seems the 5V RGB cable may have had its insulation damaged near the PSU frame. This could be enough to disable it. https://pcpartpicker.com/list/TJCVyg
W
wintery_kid13
09-29-2016, 08:45 AM #1

Your gaming PC stopped working suddenly with a crackling sound and no power detected from the PSU. It seems the 5V RGB cable may have had its insulation damaged near the PSU frame. This could be enough to disable it. https://pcpartpicker.com/list/TJCVyg

P
paperclip364
Member
174
09-30-2016, 04:58 AM
#2
Remove the RGB cables from the setup. Turn off the power supply in the back panel. Re-enable the PSU. Attempt to start the system once more. Functions correctly?
P
paperclip364
09-30-2016, 04:58 AM #2

Remove the RGB cables from the setup. Turn off the power supply in the back panel. Re-enable the PSU. Attempt to start the system once more. Functions correctly?

F
FeRRaNoX
Junior Member
4
09-30-2016, 08:22 PM
#3
Your PSU is probably malfunctioning and attempting to revive it might not work. It’s better to investigate the cause before considering a warranty replacement.
F
FeRRaNoX
09-30-2016, 08:22 PM #3

Your PSU is probably malfunctioning and attempting to revive it might not work. It’s better to investigate the cause before considering a warranty replacement.

F
FlashAnimator
Member
101
10-02-2016, 08:44 PM
#4
Can you? Yeah, I guess. Most of the parts are just basic circuit components and you can theoretically desolder any broken bits and solder new bits on. Should you? Absolutely not. Aside from the extremely small risk of death (capacitors can kill, though they usually don't), it's a lot of effort, not a small amount of money, and will never be as good as it was new. I'd hit up customer service about a potential RMA, and if they say no, replace it. In my house, a PSU gets one crackle and it's out the door
F
FlashAnimator
10-02-2016, 08:44 PM #4

Can you? Yeah, I guess. Most of the parts are just basic circuit components and you can theoretically desolder any broken bits and solder new bits on. Should you? Absolutely not. Aside from the extremely small risk of death (capacitors can kill, though they usually don't), it's a lot of effort, not a small amount of money, and will never be as good as it was new. I'd hit up customer service about a potential RMA, and if they say no, replace it. In my house, a PSU gets one crackle and it's out the door

S
Seanpollak10
Member
64
10-03-2016, 05:38 AM
#5
5V from the RGB header to the wall ground seems safe, but there could be an issue with an open or short in that area. Disconnect the affected part and check if the system boots normally. It might also indicate a problem with the motherboard's RGB bus, so consider removing any extra components to test functionality.
S
Seanpollak10
10-03-2016, 05:38 AM #5

5V from the RGB header to the wall ground seems safe, but there could be an issue with an open or short in that area. Disconnect the affected part and check if the system boots normally. It might also indicate a problem with the motherboard's RGB bus, so consider removing any extra components to test functionality.

L
luna_gamer
Member
66
10-03-2016, 07:34 AM
#6
Thanks for the guidance. It's tough to figure out everything until the weekend, but I'll update you once I have more info.
L
luna_gamer
10-03-2016, 07:34 AM #6

Thanks for the guidance. It's tough to figure out everything until the weekend, but I'll update you once I have more info.