F5F Stay Refreshed Hardware Desktop Biamp Voce Paging Audio System est un système de diffusion audio avancé.

Biamp Voce Paging Audio System est un système de diffusion audio avancé.

Biamp Voce Paging Audio System est un système de diffusion audio avancé.

G
golden_fraddy
Member
216
10-04-2016, 10:40 AM
#1
Hello everyone, do any of you use Biamp's Vocia software? I'm trying to configure a setup with MS-1e, DS-10, VI-6 and VA-4300CV all connected via a Netgear AV over IP switch. Everything looks correct in the software, device IDs are set properly, but only the MS-1e appears online when I connect, while the others stay offline. That’s puzzling.
G
golden_fraddy
10-04-2016, 10:40 AM #1

Hello everyone, do any of you use Biamp's Vocia software? I'm trying to configure a setup with MS-1e, DS-10, VI-6 and VA-4300CV all connected via a Netgear AV over IP switch. Everything looks correct in the software, device IDs are set properly, but only the MS-1e appears online when I connect, while the others stay offline. That’s puzzling.

E
EthanLG
Member
162
10-07-2016, 05:11 PM
#2
Successfully reached tech support. The representative clarified the need to set up a VLAN for isolating the MS-1e controller from other CobraNet devices. I'll keep you posted on further developments.
E
EthanLG
10-07-2016, 05:11 PM #2

Successfully reached tech support. The representative clarified the need to set up a VLAN for isolating the MS-1e controller from other CobraNet devices. I'll keep you posted on further developments.

T
theseb44
Member
70
10-07-2016, 09:46 PM
#3
According to previous configurations, using a VLAN appears redundant. Instead, I’m linked directly to the MS-1e with a crossover cable. The remaining equipment connects via the switch, and traffic is routed from the switch to the LAN2 port on the MS-1e. The same problem persists.
T
theseb44
10-07-2016, 09:46 PM #3

According to previous configurations, using a VLAN appears redundant. Instead, I’m linked directly to the MS-1e with a crossover cable. The remaining equipment connects via the switch, and traffic is routed from the switch to the LAN2 port on the MS-1e. The same problem persists.