F5F Stay Refreshed Power Users Overclocking Best overclock for i5 4690k

Best overclock for i5 4690k

Best overclock for i5 4690k

J
51
11-06-2016, 04:23 PM
#1
I own an i5 4690k built with an ASUS Z97-c motherboard. The CPU is cooled by a Corsair H75 water cooler, and I'm curious about the optimal overclocking level. Since I'm new to this process, I'm unsure what would be ideal for my setup. My stress tests have stabilized around 62°C or higher. Any guidance would be greatly appreciated.
J
JoaoGabriel456
11-06-2016, 04:23 PM #1

I own an i5 4690k built with an ASUS Z97-c motherboard. The CPU is cooled by a Corsair H75 water cooler, and I'm curious about the optimal overclocking level. Since I'm new to this process, I'm unsure what would be ideal for my setup. My stress tests have stabilized around 62°C or higher. Any guidance would be greatly appreciated.

C
Chiller9592
Senior Member
670
11-22-2016, 09:19 AM
#2
Only attempt to proceed cautiously, the C isn't ideal for initial setup. Consider increasing it gradually by one unit at a time using the multiplier, and add voltage only when necessary. Keep monitoring temperatures continuously.
C
Chiller9592
11-22-2016, 09:19 AM #2

Only attempt to proceed cautiously, the C isn't ideal for initial setup. Consider increasing it gradually by one unit at a time using the multiplier, and add voltage only when necessary. Keep monitoring temperatures continuously.

K
kungfutyla
Posting Freak
780
11-23-2016, 04:14 AM
#3
You're limited to moving slowly, the C isn't ideal for OCing, so try increasing it gradually by adding the multiplier one step at a time and adjusting voltage only when necessary, keep monitoring temperatures continuously.
K
kungfutyla
11-23-2016, 04:14 AM #3

You're limited to moving slowly, the C isn't ideal for OCing, so try increasing it gradually by adding the multiplier one step at a time and adjusting voltage only when necessary, keep monitoring temperatures continuously.

R
RulwenJr
Posting Freak
786
11-23-2016, 06:13 AM
#4
all 4690k cpus are overclocked slightly differently. mainly, you adjust the multiplier and voltage in the BIOS, then run a stress test using something like Prime95 and watch the temperatures while it runs for about ten minutes to a couple of hours. if the temps stay stable (no BSOD), restart the process. this is my usual method. check out my blog for details. i started with 4.0ghz at 1.15v and increased from there. just set the voltage, raise the CPU until it becomes unstable during testing, then increase the voltage by 0.1 to 0.2 and keep going. intel suggests a maximum voltage of 1.3 for these CPUs. if your voltage is too high for a certain speed, the heat increases significantly. there’s a balance point where temperatures are optimal depending on the ratio of voltage to CPU speed. it takes time—patience is key. it might take a few days to get stable overclocking results.

your setup might vary slightly.
[link]

think of it this way: cpu voltage = gasoline, cpu speed = engine. if you run quarter-mile stress tests with a turbo CPU and only 20psi fuel (voltage), your results won’t be great because the engine will stall midway. you need to tweak the "boost" and "fuel pressure" for the best performance.

comprende?

also, don’t attempt overclocking without a better CPU cooler—it’s risky.
R
RulwenJr
11-23-2016, 06:13 AM #4

all 4690k cpus are overclocked slightly differently. mainly, you adjust the multiplier and voltage in the BIOS, then run a stress test using something like Prime95 and watch the temperatures while it runs for about ten minutes to a couple of hours. if the temps stay stable (no BSOD), restart the process. this is my usual method. check out my blog for details. i started with 4.0ghz at 1.15v and increased from there. just set the voltage, raise the CPU until it becomes unstable during testing, then increase the voltage by 0.1 to 0.2 and keep going. intel suggests a maximum voltage of 1.3 for these CPUs. if your voltage is too high for a certain speed, the heat increases significantly. there’s a balance point where temperatures are optimal depending on the ratio of voltage to CPU speed. it takes time—patience is key. it might take a few days to get stable overclocking results.

your setup might vary slightly.
[link]

think of it this way: cpu voltage = gasoline, cpu speed = engine. if you run quarter-mile stress tests with a turbo CPU and only 20psi fuel (voltage), your results won’t be great because the engine will stall midway. you need to tweak the "boost" and "fuel pressure" for the best performance.

comprende?

also, don’t attempt overclocking without a better CPU cooler—it’s risky.