Adjusted memory clock speed to 3200 MHz but no signal detected during startup.
Adjusted memory clock speed to 3200 MHz but no signal detected during startup.
I handle games smoothly, yet Overwatch often crashes for me. This pushes me to look for solutions. Hardware: AMD Ryzen 5900X, Prime X570-P motherboard, Masterliquid ML240L V2 RGB GPU, AMD Radeon RX 6800 XT, Lancool 205 Mesh C case, ATX chassis, Corsair RMX rm850x RAM. Storage: Teamgroup T-force Vulcan Z DDR4 16GB (only 8GB installed). I’m worried about connecting both RAM sticks without issues on my monitor.
I was planning to share a quick update on my 1000s of posts, but I should probably stay focused. Right now, I'm just trying to get things done instead of getting caught up in this.
Did you only modify the memory frequency in BIOS or did you turn on XMP/DOCP? You can't just tweak the frequency without fixing timing and voltage settings, which is why XMP profiles exist. Also, if your motherboard's BIOS is outdated, updating it could be beneficial. They enhance system stability and boost memory performance. The Ryzen 5900X on an X570 should handle DDR4-3200 with ease, up to around DDR4-3600.
Reset the CMOS and then configure BIOS with the initial XMP profile. Adjusting clocks can cause RAM issues since the Jedec timing isn't compatible with XMP speeds.