3D Printed WC loop?
3D Printed WC loop?
Hey, I just finished creating some files in Fusion 360 to transform my AM4 AMD Closed WC loop into an open loop that fits any PC. I made a water-tight res and filled the tubing with distilled water tomorrow to prevent clogs inside the small fins. Most of the loop—res, radiator, fans—will be outside the PC, while only a few 3D printed components will be inside, connecting the block/pump to the reservoir. I plan to use a heat gun to bond the layers thoroughly. The res is now fully watertight.
Do you think it’ll work?
Files will be available soon; if you need them right away just send me a message.
I tested it, but it doesn't work properly. It might hold water when you add some, but once it handles the pressure and water it leaks continuously. It caused all over my PC to leak, and it broke completely. Do not attempt this unless you're using a very high temperature filament!!!!!!