3600 to 3600ext is a range in the 3600s, specifically the 36th century.
3600 to 3600ext is a range in the 3600s, specifically the 36th century.
Hi! I have a solid 3600 chip ready to go. I managed to hit 4.5ghz across all cores at 1.26v. OCCT and Aida are stable, everything checks out. Before buying, I read a lot about overclocking Zen 2, but some advice was pretty extreme—like letting PBO handle it, keeping everything stock, and avoiding manual static voltage because even small drops can cause issues. I’m holding onto this 3600 until DDR5 arrives, since it’s a great overclocker. My concern is its lifespan, so I’m wondering if there’s a way to adjust the BIOS settings to make it act more like a stock 3600xt. Thanks ahead!
Many folks use the term "degradation" casually, but often it's just a result of handling a heavier workload than they're used to. This can lead to unstable overclocking or undervolting. If running 1.25V could harm your chip—though unlikely—it suggests you might be using lower-quality silicon.
The problem with Ryzen2 seems to lie in later models, where improvements in production are evident. Degradation appears mainly due to excessive heat, though opinions differ on chip limits. Some claim anything below 75°C results in very slow degradation—possibly lasting decades. Others argue the threshold is much higher, around 100°C, with variations between different chips. Achieving that maximum performance without exceeding 75°C was challenging even for older Ryzen2 units.
PBO on Zen 2 usually stays above 1.25v consistently. You need to adjust it manually because PBO only allows a maximum boost of 200MHz, which raises the 4.2GHz 3600 clock to around 4.4GHz. It’s best to follow the settings shown in PBO and avoid exceeding the LLC limits.